georgeg
Guest
I've splurged on some nice big (159 mm) 100w driving lights for my 1150.
I've read the auxilary lighting how to, and will be doing pretty much the same.
Since my lights are a fair bit bigger, and most likely heavier than the ones shown, I think I'm going to need a stronger bar.
I was planning to use 20 mm box section steet and mount it using the oil cooler mounts.
Does anyone know if the oil cooler mounts are strong enough for this purpose and if the nuts (which I can't see without removing the beak) are captive.
If the nuts aren't captive could someone point me to some documentation on how to remove the beak.
Cheers
Comments welcomed.
I've read the auxilary lighting how to, and will be doing pretty much the same.
Since my lights are a fair bit bigger, and most likely heavier than the ones shown, I think I'm going to need a stronger bar.
I was planning to use 20 mm box section steet and mount it using the oil cooler mounts.
Does anyone know if the oil cooler mounts are strong enough for this purpose and if the nuts (which I can't see without removing the beak) are captive.
If the nuts aren't captive could someone point me to some documentation on how to remove the beak.
Cheers
Comments welcomed.
