KTM 0.12 mm Angled Feeler gauge

Thought you KTM guys might be interested in this as it took a lot of surfing to find them.

I think these are motion pro products. www.motionpro.com/motorcycle/partno/08-0398

www. below is for a UK stockist. I got part number 00-390.EA for my Husaberg FE 450. They make the difficult job of checking valve clearance much easier. IMHO worth purchasing.

www.oro2u.com/acatalog/FEELERS.html

For an FE450 Berg, just tighten finger tight then back off one flat, much simpler

Timolgra said:

For an FE450 Berg, just tighten finger tight then back off one flat, much simpler

Click to expand...

Timolgra, yes I do agree, however, I did use both methods as this was the first time I had set valve clearance for a long time. I wasn't confident to rely purley on the 1/6th turn method. I'm just a bit padantic, OCD even. As you have indicated and I found out, to get a standard feeler gauge in there is flipping difficult.

I used the below as a guide for a first time numpty, someone might find it useful .

http://www.youtube.com/watch?v=hWS9RuEQzc8