jpod
Registered user
Morning all, I elbow deep in grease and oil trying to replace the clutch on my 2011 R1150GS. I'm following the Haynes manual and I've got practically all the bits off.
I have just removed the clutch slave cylinder and now it says to remove the pushrod... how in feck do you do this?
I've been pulling and wiggling it like hell for 10 minutes and it's going nowhere...
Is it necessary to remove it? For the 1100 they say not.
Side note, there was some seriously gunky brown thick oil/grease in the space behind the slave cylinder: is that gearbox oil leaking back, a shot slave cylinder spitting grease or what?
Please, any help greatly appreciated. BTW I HAVE tried to search for this.
I have just removed the clutch slave cylinder and now it says to remove the pushrod... how in feck do you do this?
I've been pulling and wiggling it like hell for 10 minutes and it's going nowhere...
Is it necessary to remove it? For the 1100 they say not.
Side note, there was some seriously gunky brown thick oil/grease in the space behind the slave cylinder: is that gearbox oil leaking back, a shot slave cylinder spitting grease or what?
Please, any help greatly appreciated. BTW I HAVE tried to search for this.