Migsel mount on 1150 GSA

Undo the speedo cable at the wheel.
Take the underscreen off.
Undo the two nuts holding the speedo in place.
Pull the speedo out of the panel until you can take the Migsel mount out.
Reassemble in reverse order...
 
Undo the speedo cable at the wheel.
Take the underscreen off.
Undo the two nuts holding the speedo in place.
Pull the speedo out of the panel until you can take the Migsel mount out.
Reassemble in reverse order...

Bloody hell... Really ?

I thought it would be a hidden grub screw!

Ok thanks, think I'll do it when the weather warms up a bit.
 
20 mins actually as I'm swapping over to another 1150 GSA ;)

Probably nearer 18 minutes as you should develop some efficiencies/improvements in your method during the initial removal which can then be implemented when you install on the other GSA :D
 
migsel

Worst bit is getting the 2 nuts back onto the speedo bolts.... without dropping them several times due to lack of space and large stubby fingers....
 


Back
Top Bottom