Tarmac Teaser
Guest
Anyone about that can make two of these can holders but a bit smaller.
I can supply the can.
I can supply the can.
how would sir be paying as I don't have enough materials?
what sort of can to make sure it's agood fit and the rubber bungs are right to stop static charge building up cos you could get flash over it's not unheard of.
funny cos I was thinking today about making some jerry can holders for my truck which look very similar to this.
what sort of can to make sure it's agood fit and the rubber bungs are right to stop static charge building up cos you could get flash over it's not unheard of.
funny cos I was thinking today about making some jerry can holders for my truck which look very similar to this.
Tarmac Teaser
Guest
There for 5 litre jerry cans which no one seems to sell for some reason.
There could be a market in these me thinks.
Would a cheque be ok or paypal
There could be a market in these me thinks.
Would a cheque be ok or paypal
Last edited:
I've seen a couple of 5 litre jerry cans they look like toy ones
the answer is yes it can be made I'd need to make the hinge from scratch and need to get the angle iron to make the trays then build the upper section. using the can as a form. Where had you planned to mount them? it'll affect how strong I need the upper and lower brace to be.
the answer is yes it can be made I'd need to make the hinge from scratch and need to get the angle iron to make the trays then build the upper section. using the can as a form. Where had you planned to mount them? it'll affect how strong I need the upper and lower brace to be.
Tarmac Teaser
Guest
Pm sent
could probably use a donor hinge to save time will have a look at the can and think about it
have sent you my nuimber
have sent you my nuimber
Similar threads
