Alloy plate cut - 260mm * 250mm * 6mm

Have an alloy plate needing cut if it can be done at a reasonable enough price.

Basic measurements are 260mm wide by 250mm deep and 6mm thick with slightly rounded corners. Want good hard grade alloy. It will be used as a luggage rack but doubles as a topbox mounting plate.

From the diagram:

Each hole is the same size: 50mm by 5mm. 15mm in from the edge. The top and bottom side ones are 20mm from the top/bottom of the plate with 30mm distance to the middle cut out. The bottom cut outs are 20mm either side of the centre of the plate (so 40mm distance between them in total).

I'll also want a small plate made up, approx 30mm by 150mm. I'll get measurements for that in a bit.

And the second smaller plate I need but as tough as the main plate (I.E. same material)

Either can be made in alloy or stainless steel, just needs to be tough enough to have a top box bolted to it.

Give me a bell tomorrow at the workshop