DR350 Indicator Problem

dmac

Active member
UKGSer Subscriber
Joined
Mar 20, 2012
Messages
243
Reaction score
0
Location
Co Fermanagh, N Ireland
Was going to go for a run today and when I tested the indicators before setting off I realised I had no left hand side at all. Right is working fine but not the left. While checking the bulbs I found a lot of water inside the lens, and the fittings are coroded! Can I assume that its the fittings etc and just go all out and replace them with new LED's maybe or is there a chance its the Switch? Am I right in thinking if the circuit isnt complete for both front and back the flashing unit wont work?
 
It's easy to swop over connections for front indicators - remove headlight cowl and follow wires to connectors.
Remove side-panel(s) to find rear connectors. If not enough slack to swop over then remove working indic. to use as tester.
 


Back
Top Bottom