JohnGS1100 Tuning Chip

I hope he gets well soon.

His talent and willingness to share his knowledge in the form of making these chips available when all others hide their mapping is very welcome

Difficult to imagine more improvement in you Oilhead / £, than one of John's chips
 
John has asked me to ask you guys needing to get in touch to email him instead - chipixel@hotmail.com

He is not using the forums at the moment.

I contacted him on this email address two days ago. He asked for full details of my bike, if it had a de-cat, aftermarket exhaust/air filter.
He also requested that I sent photos of the fuse box so he could be certain it has an oxygen sensor or not. (R1100GS).

He claims in his own words...

"Will make much more torque and power and better consumpttion.
The cost is 80 euros it is worth!!
From 78 hp to 92 hp faster at low rpms driving by a gear up".


All sound good, so €80 sent via paypal. Looking forward to fitting it.:bounce1
 
Hi to all |Ukgser for. There was a long time that i had trouble with my health.

I m fine now and working again.

You can found me to my email Chipixel@hotmail.com
and to my fb John Gemi my nickname.

Thanks :)
 
Glad to here you are well John.




Now where's my chip lolllll:D:D
 
Hi to all |Ukgser for. There was a long time that i had trouble with my health.

I m fine now and working again.

You can found me to my email Chipixel@hotmail.com
and to my fb John Gemi my nickname.

Thanks :)

Hi John, very pleased your health has improved. I have used your stage 5 chip, I have been using your stage 7 chip for approximately three years without ANY ISSUES.

I will DEFINITELY be ordering your stage 10 chip once you have had time to clear your “ backlog “

Best regards Alan. :steptoe
 
The same alanbmwgs.


Send to my email fully affress and full bike details.
Will send last update.
 
Well worth the wait.

Fitted my stage 9 today and all I can say is that it's fantastic. :D:D:D
Thanks John.
 
Fitted my stage 9 today, I removed a techlusion 83i/Tfi power box to fit it
So far its smoother and seems quicker, front wheel has stayed on the floor so far
My bike spec is 1200 injectors, remus with the baffle in(i leave for work at 5am), not sure if I should have a more free flowing airfilter or possibly a 1100rt air intake
 
For UKGser members there is another price for chip.
Because i Love UKgser forum.

If anybody wants a chip please contuct to my email Chipixel@hotmail.com

Thanks to all !!!!!;)
 
Hi ssray.

Dyno results By GS AIR TUBES and BY RT large tubes here is the dyno.

Up GS tubes
down RT tubes

photo :
Mar2831long_short.jpg


DYNO

25507820_973050289521934_7444019635229267802_n.jpg


Blue line torque by RT tubes, Red line power by RT tubes.
Green line torque by GS tubes and orange line by GS tubes.
bottom is the AFR (full open throttles.

As you see the GS tubes gives more torque and 94 Hp.
The RT tubes gives more power *98 hp but lower torque at middle rpms.

The dyno results is to rear whell from an R1150GS single spark by stage 9 chip and has delete cat free KN air filter and free exhaust no other modification..

Same result and to the R1100GS.


...and here is a dyno by stock chip (R1150GS) (84 hp).

15765.jpg
 
R1100rt air tubes located and ordered, will update when they are fitted, just in time for snow!!!!
 
SERVICE MANUAL ALL BMW BIKES (1993-2011) - ADJUSTMENTS BOXERS 1993-2005

Oilhead_Maintenance BOXERS 1993-2005 BMW
https://drive.google.com/open?id=0B7b6GlMSZji5bXJ0cjFUclNjaVU

SERVICE MANUALS ALL BMW 1991-2011
https://drive.google.com/file/d/15mNS6UN8mFyAmA2aSERcyx8iE2o2yF-y/view?usp=sharing

Adjustment TPS boxers 1993-2005
https://drive.google.com/file/d/1lBW8ldi3fU12t5mHg32rgbh5PfZgqlcw/view?usp=sharing

Thanks :)

Thanks for posting these good old manuals. Since the Oilheads run better with the TBs set up correctly I’d like to make two corrections to their content.

1. Zero=Zero is a bad alignment procedure that results in the throttle plate open too far. Zero=250mV is a correct, better procedure.

2. The correct tps voltage at idle is 340 mV.

Here’s a link to the background and z=250: https://advrider.com/f/threads/tps-...-beyond-zero-zero.996719/page-6#post-32357006
 
John, you don't seem to be receiving my emails.

I sent one last week? Has it gone in your spam folder? Followed the email address you posted on here.

Thank you.

Tufty
 


Back
Top Bottom