Torque Talk

denny

Registered user
Joined
Nov 5, 2010
Messages
462
Reaction score
0
Location
Istanbul
I recently bought a larger IMS fuel tank for my WR250R to replace the piddly 7 litre OEM. I'll need to transfer the fuel pump which has 5 or 6 little bolts that require torquing to 4NM however the torque wrench I have is good for 8-60NM. Should I go out & buy a suitable wrench or just tighten them by 'feel'? Pretty sure going by feel is ok most of the time, but not for bolts attached to the fuel tank??
 


Back
Top Bottom