Interphone Mic - re attach mic foam surface mount

rjsmith26 · Aug 15, 2016

Changed to an Interphone 3 months ago from autocom.

Really pleased with except the surface mount mic foam wind mount just fell off one day.

Apart from superglue or similar - any tips for re attachment?

Just thought I would ask as sure this will have happened to others as the foam cover seems rather flimsily attached.

Piss taking or genuine answers welcome

Nutty · Aug 15, 2016

rjsmith26 said:
Changed to an Interphone 3 months ago from autocom.

Really pleased with except the surface mount mic foam wind mount just fell off one day.

Apart from superglue or similar - any tips for re attachment?

Just thought I would ask as sure this will have happened to others as the foam cover seems rather flimsily attached.

Piss taking or genuine answers welcome

They all do that eventually. I took the foam from the boom mike, cut a groove on the side that was going to be stuck down, wrapped round the whole fixed mike, then stuck it back to the inside of the helmet.

That made sense when I typed it!

rjsmith26 · Aug 15, 2016

Thanks Nutty

Deleted account 240118001 · Oct 19, 2016

I had the same problem, just glued it back on.

I just recently removed my unit from my old TourX4 lid and installed it into the Shoei ADV and also bought a separate install kit and have installed it into my new Shark Raw lid too. Noticed that even the new mic cover was loose so pre-empted any issues by gluing that too. Works fine and no damage to the microphone and/or lid.

Interphone Mic - re attach mic foam surface mount

rjsmith26

Well-known member

Nutty

Registered user

rjsmith26

Well-known member

Deleted account 240118001

Registered user

Similar threads