Hi. Kind of new here but have been around for a few years.
Purchased a 53 plate 1150rt a few weeks ago to use on my commute to work and thoroughly enjoying her on the Highland roads.
Popped the filler cap today whilst checking a new key and noticed a puddle of water sitting around the filler neck . Does anyone know where the breather/overflow goes to or what route it takes, haven't seen any clear diagrams. Not really wanting to take Tupperware off at present due to a lack of space.
I tried a bit of harness wire but it only goes in a cm or so, I have a compressor but no access at present.
Cheers in advance
Purchased a 53 plate 1150rt a few weeks ago to use on my commute to work and thoroughly enjoying her on the Highland roads.
Popped the filler cap today whilst checking a new key and noticed a puddle of water sitting around the filler neck . Does anyone know where the breather/overflow goes to or what route it takes, haven't seen any clear diagrams. Not really wanting to take Tupperware off at present due to a lack of space.
I tried a bit of harness wire but it only goes in a cm or so, I have a compressor but no access at present.
Cheers in advance