Lads, I don't know where to put this so I'm gonna start here first.
I have a Givi Tanklock ring on my GS (BF22......I think) it was fine on my previous 2007 but I recently changed to another 2007 and for some reason the tank bags will not clip down securely onto the ring.
I need to raise the flange a few millimeters up. I know I could do it with washers but it would look terrible. I was wondering could an exact replica of the ring (without the flange) be manufactured in some sort of resin or metal to sit between the filler cap housing itself and the Givi plastic flange......basically a circle with the screw holes in the correct place.
I hope that makes sense and I await the helpful suggestions.
(C'mon Pat......this is right up your street)
I have a Givi Tanklock ring on my GS (BF22......I think) it was fine on my previous 2007 but I recently changed to another 2007 and for some reason the tank bags will not clip down securely onto the ring.
I need to raise the flange a few millimeters up. I know I could do it with washers but it would look terrible. I was wondering could an exact replica of the ring (without the flange) be manufactured in some sort of resin or metal to sit between the filler cap housing itself and the Givi plastic flange......basically a circle with the screw holes in the correct place.
I hope that makes sense and I await the helpful suggestions.
(C'mon Pat......this is right up your street)
