As you will realise I am trying to master Basecamp. I have had reasonable success constructing a number of routes, transferring them into my nav5 and then going for rides on my bike following the instructions. Admittedly one ride was a disaster sending me back and forth between two roundabouts.!!
My questions are .
Apart from the ‘start’ and ‘finish’ points, why does Basecamp suddenly make a few of the other points become ’alerts’, when all the rest are ‘wont alert’, when I have given no instructions for ‘alerts’ to happen?
I know how to change from ’alert’ into ‘wont alert’, am I right to presume this will not have an effect on my programmed route?
Thanks in anticipation for any help, I hope I’m not appearing too much of an idiot!
My questions are .
Apart from the ‘start’ and ‘finish’ points, why does Basecamp suddenly make a few of the other points become ’alerts’, when all the rest are ‘wont alert’, when I have given no instructions for ‘alerts’ to happen?
I know how to change from ’alert’ into ‘wont alert’, am I right to presume this will not have an effect on my programmed route?
Thanks in anticipation for any help, I hope I’m not appearing too much of an idiot!