dave61
Registered user
Hello all,
First post as I usually find answers by searching previous posts.
I`ve just replaced the pair of bearings in the Final Drive on my 2002 1150GS after they gave up a mile & a half from home,which was lucky I know, but I noticed the large oil seal had a couple of inches of the inner lip had turned over instead of being nice & flush.
I used the end of a cable tie to carefully push it back but wanted opinions on wether this will be ok or should I get another seal as I`d noticed on a Youtube "How to" video that the same had happened on his.
Cheers
Dave
First post as I usually find answers by searching previous posts.
I`ve just replaced the pair of bearings in the Final Drive on my 2002 1150GS after they gave up a mile & a half from home,which was lucky I know, but I noticed the large oil seal had a couple of inches of the inner lip had turned over instead of being nice & flush.
I used the end of a cable tie to carefully push it back but wanted opinions on wether this will be ok or should I get another seal as I`d noticed on a Youtube "How to" video that the same had happened on his.
Cheers
Dave