richard kirby
Registered user
Hello, Im looking for some technical advice,
I have purchased a breaker only 2016 R1200 GS LC
I then purchased a 2014 frame, ecu, lock set and clocks.
I have built the bike onto the frame however the bike wont run when the back light is plugged in and when you indicate the engine management light flashes instead.
I have taken the bike to BM to get the clocks changed from KM to Miles and the say that the general module will not programme in. this is the lighting module.
They ordered the correct general module from the chassis number but it doesn't fit the wiring loom om the 2016 bike.
The 2014 module is much larger than a 2016 module.
Apparently a new one comes blank and is coded in in the workshop, but there are two to pick from and they don't know which one to order.
Could anyone wipe the data from the one I have? or suggest a alternative? other than buying a 2014 loom.
Thank you for any helpful advice.
I have purchased a breaker only 2016 R1200 GS LC
I then purchased a 2014 frame, ecu, lock set and clocks.
I have built the bike onto the frame however the bike wont run when the back light is plugged in and when you indicate the engine management light flashes instead.
I have taken the bike to BM to get the clocks changed from KM to Miles and the say that the general module will not programme in. this is the lighting module.
They ordered the correct general module from the chassis number but it doesn't fit the wiring loom om the 2016 bike.
The 2014 module is much larger than a 2016 module.
Apparently a new one comes blank and is coded in in the workshop, but there are two to pick from and they don't know which one to order.
Could anyone wipe the data from the one I have? or suggest a alternative? other than buying a 2014 loom.
Thank you for any helpful advice.