1200gs engine management reset

[Gstom]

I seem to remember a thread about a procedure involving switching engine on and off, opening and closing throttle etc.
I think it was to re calibrate electronic settings for the engine.
Anyone remember what the thread was called and point me in the right direction.
My bikes a 2018 1200gs.
Cheers.

 

[ChazzyB]

TPS or "throttle position sensor" is what you could be looking for.

I have done it. I couldn't say it made the slightest difference. Nor could I tell you now where I read it, or if I even wrote it down. My bad.

 

[autogs]

it will make no difference to an lc

 

[grant123]

Will need plugging in, one of the stipulations for any EURO4 bike was it would store fault codes until reset by connecting in the form of a code reader.

 

[Gstom]

Thanks to all.

 

[Winjar]

I seem to remember a thread about a procedure involving switching engine on and off, opening and closing throttle etc.
I think it was to re calibrate electronic settings for the engine.
Anyone remember what the thread was called and point me in the right direction.
My bikes a 2018 1200gs.
Cheers.

Not me I find on internet

•Step 1: Hold the throttle to the 100% wide open position and do not let go.
•Step 2: With the throttle still held fully open, turn on the ignition (but don’t start the engine) and allow for all checks to complete.
•Step 3: Turn off the ignition.
•Step 4: Close the throttle.
•Step 5: With the throttle fully closed, turn on the ignition (but don’t start the engine) and allow for all checks to complete.
•Step 6: Turn off the ignition.
•Step 7: Without touching the throttle start the engine and allow it to idle for a minimum of 3 minutes.