Anyone else had this issue, i wanted to adjust the gear lever down one spline and now the side stand spring catches, is there a way around this other than moving the lever back up one??
Cheers
Mark
Cheers
Mark
2011 Side stand catching on gear lever slightly
- Thread starter mpgscott
- Start date
On my 2010 adv the rubber end piece of the lever can be adjusted without having to move the whole lever.there is a grub screw to loosen and then rotate the end piece on its eccentric.I don't know if its the same on standard gs 
Hi Mark shove a picture up and lets have a look
On my 2010 adv the rubber end piece of the lever can be adjusted without having to move the whole lever.there is a grub screw to loosen and then rotate the end piece on its eccentric.I don't know if its the same on standard gs
adv only
No bother i will get a pic to show.
Cheers
Cheers
AberdeenAngus
Registered user
similar thread here
I see what you mean. So I could just slide the rubber peg backwards along the groove?...
If so, I'm guessing I just need to loosen the torx bolt underneath?..
Roymondo
Registered user
Don't think it slides along that groove (which is more of a slot really). If you slacken the bolt, you can then rotate the tip of the pedal. As it is mounted off-centre, rotation provides a degree of fore-aft and up-down adjustment.
