640 adv in kit form

[mikeyboy]

Double Meh!!! Excuses

Right stop Fecking about and get started!

There are people waiting !!!

Ok,today's task,
To clean and degrease every component for inspection.

 

[DrFarkoff]

Ok,today's task,
To clean and degrease every component for inspection.

3 days have gone by.......


Jeez Sounds like some new Dirge from Chris De Burgh!!

 

[DrFarkoff]

Cough Cough My Popcorn subscription is needing renewed!!!

 

[mikeyboy]

Cough Cough My Popcorn subscription is needing renewed!!!

Crikey, been busy trying to earn a living

 

[Santa-2512]

Awesome stuff

Mikey, you are a Legend!

 

[mikeyboy]

Yay some parts have arrived
Best crack on
Casings have been cleaned and all the bearings checked

 

[mikeyboy]

In with new seals

 

[mikeyboy]

Kick start mech,
Gearbox clusters and selectors,
Then the crank

 

[mikeyboy]

Easy peasey

 

[mikeyboy]

Next is the starter gears

 

[mikeyboy]

New sprag clutch,these are a bit of a known weakness on any big single,
The old one was showing some signs of wear so no fucking about

 

[mikeyboy]

Alternator rotor can go on now

 

[mikeyboy]

Over to the other side,

 

[mikeyboy]

New timing chain

 

[mikeyboy]

And new guide blades,
Not too much wrong with the old ones but piece of mind

 

[mikeyboy]

Oil pumps in

 

[mikeyboy]

Primary drive and balance shaft

 

[mikeyboy]

New clutch friction and plain plates

 

[mikeyboy]

Springs measured up just fine

 

[mikeyboy]

Job done till I get some more bits