bee em alarms question

[Hairnet600]

had mine in to have a new plipper recoded

they had to change the sensor thing on dash cos old one was ^%*£ed - fair enuff only 14 quid

they then say that the thingy you press on when the plipper doesnt work/or for programming isnt doing its job

theyve asked me to provide the other black key to try that one

is recoding always this difficult????


williams couldnt have been more helpful btw

 

[Kenny Rodkiss]

The alarm handbook says that to Synchronize the remote you should,
within 10 meters of the bike press both buttons on the remote and hold down for approx. 10 seconds until the led on the remote goes out.
Release both buttons.
The remote led should now come on and stay on.
Then press either button and the alarm and remote should sync. themselves.
The remote led should then go out.

Job done in 30 seconds

 

[Hairnet600]

...

thats to sort the original remote if you press buttons too much or take out batteries



thanks anyway