Does anyone here use one with a 1100/1150? Motorworks do. 350mm table, will it fit? I'm thinking if buying as we have a steep drive to the garage.
Cheers
Cheers
Bike turntables
- Thread starter Orinoco
- Start date
Two pieces polyproplene 35cms dia, small nut n' bolt through middle. With this one top bit is about 2mm and the other 6mm
The material is pennies from the guys who make up sump boxes and other drainage items
The material is pennies from the guys who make up sump boxes and other drainage items
luke scott
Registered user
http://www.becker-technik.de/Rangie...eite/body_rangier-as_fur_haupt_und_seite.html. I use this trolley. Easy to use and it allows you to move the bike to any part of the garage out of the way after you spin it round. 
russell
Registered user
had a turntable for over 10years. still works perfectly. marvellous device. used with RT and GS. does exactly wot it says on the tin, but prob. comes in a box
Last edited:
That looks exactly the same as the one I made, a bit of PTFE spray / lube between the pieces helps too. Whatever you do try to keep the turntable as low as possible. The first one I made was 10mm high and hauling the R1100GS on to the centre stand on the turntable was much more difficult than on the floor.
russell
Registered user
put some rubber mats the same thickness as the turntable under each wheel. saves a double hernia
Thanks folks
Belper phil
Registered user
Nice - i do like that and currently in the market!
Similar threads
