On my R1250RT I've replaced my Denali D4 pair with a pair of D7 pro bought off this good forum.
I only have one Cansmart and wanted to keep the D7 brake-light, so, as suggested by the seller on here, I connected the three remaining Cansmart circuits
as follows:
4 top and bottom LEDs both sides wired as one pair on one channel, using a double-ended cable - this is main beam.
The centre 3 LEDs, each side wired to its own channel.
For night riding on dip, the top and bottom LEDs are off. But on dip, the centre 3 on both lights I have turned right down to 10% & I'm still getting flashed by oncoming cars.
Just asking whether anyone else has had these problems and can offer suggestions for me to keep both sets of 3 central LEDs on dip at night ?
Also going to post this on the R1250GS section as I'm guessing that's where most of the users on here are.
I only have one Cansmart and wanted to keep the D7 brake-light, so, as suggested by the seller on here, I connected the three remaining Cansmart circuits
as follows:
4 top and bottom LEDs both sides wired as one pair on one channel, using a double-ended cable - this is main beam.
The centre 3 LEDs, each side wired to its own channel.
For night riding on dip, the top and bottom LEDs are off. But on dip, the centre 3 on both lights I have turned right down to 10% & I'm still getting flashed by oncoming cars.
Just asking whether anyone else has had these problems and can offer suggestions for me to keep both sets of 3 central LEDs on dip at night ?
Also going to post this on the R1250GS section as I'm guessing that's where most of the users on here are.
