End cans and headers

[Vanguard]

If you replace the end can/headers and de-cat the bike does it flag up any error warning lights like it would a car ?

What is the cost for a Hilltop remap by the way ?

 

[RedRick Esq.]

If you replace the end can/headers and de-cat the bike does it flag up any error warning lights like it would a car ?

What is the cost for a Hilltop remap by the way ?

End cans and headers do not show warnings
diagnostics at service may show if you remove the flappy thing but that is it

as for Hilltop if you are a first time offender cost is £350 i believe

 

[Vanguard]

Thanks Redrick, if I take the primary cats off my BMW car I'd get all manor of warning lights , good to know the bikes not so much then

 

[crotchrocket]

If its of any use, i installed the Mivv headers, which retain the exhaust valve motor / connectors (but not the valve of course) I think with the others, you just remove the motor unit entirely.

 

[Vanguard]

Does the valve serve any useful purpose or is it just to keep the noise down below certain speeds ?

 

[backstreet hero]

It's time to stop using aliases to post spurious topics just to generate more business…

 

[Vanguard]

It's time to stop using aliases to post spurious topics just to generate more business…

Great first post, who's that comment aimed at ?

 

[stick]

Great first post, who's that comment aimed at ?

My thoughts exactly .... Could it be firefly

 

[backstreet hero]

I was off the meds that day and when that happens I can end up writing anything! Clearly I was writing about a different subject altogether. Doh!!!!!

 

[jim.rouse.39]

I replaced the cat and put the Akro on.the instruction tell you to disconnect the valve and leave the little black box on the engine.went to Belgium the other week end and found the bike goes and breaths a lot better.i took the baffles out of the end can and now it sounds brilliant too


Sent from my iPad using Tapatalk