Does anyone know where you can get the individual feeler gauges for setting valve clearances on a GS, the ones with the bent end 
Feeler Gauges
- Thread starter PIGGLET
- Start date
the ones with the bent end
Like these??
http://www.justoffbase.co.uk/Feeler...3eSc34RbhyRe34Pa38Ta38LbN50?sc=9&category=152
Yeah, I know. At the moment I've got a set of metric and a set of imperial both flat blades. I just though it would be easier to set up if I had 2 of the same, especially for the rocker end float 
I know snap-on do a kinked set but would prefer individuals.
IT bods won't let us look at shopping sites at work so I'll check out the above link later
I know snap-on do a kinked set but would prefer individuals.
IT bods won't let us look at shopping sites at work so I'll check out the above link later
Can't bloody Edit my post
Yeah, I know. At the moment I've got a set of metric and a set of imperial both flat blades. I just though it would be easier to set up if I had 2 of the same, especially for the rocker end float
I know snap-on do a kinked set but would prefer individuals.
IT bods won't let us look at shopping sites at work so I'll check out the above link later
... Wurth; they sell individual feelers at reasonable cost
Aha, thats them, couldn't remember the make
Aha, thats them, couldn't remember the make
When you get them, put a piece of nylon cord or string through them in their pairs and attach a bulldog clip to one end of the cord.
Clip the bulldog clip to one of the engine fins, then when one slips out (as is inevitable) you don't end-up hunting for it on the floor or in the oil drip-pan!
Top Tip 
Similar threads
