FIAMM master blaster Horn

[DC]

ok Guys I've searched through lots of the forum but can't find the answer ( in fact its confused me more )

I would like to purchase the titled Horn and fit to a 2015 GSA. NN sells the horn but they are not sure if it will fit the bike !. The adventure bike shop also sells the horn but say it won't fit the 2014 GSA

Has any one on here fitted one to a wet head GSA ? did you need to use the can bus wiring kit or is it just a case of swapping over spade head connectors ? thanks in advance

 

[bisbee]

Have a read of the linked article A nautilus will wake the dead

http://www.docspopuli.org/articles/Motorycle_airhorn_installation.html

 

[DRAIN MAN]

used the standard canbus wiring to trip a relay which connected the horns, otherwise the canbus will trip out the fuse

 

[DC]

used the standard canbus wiring to trip a relay which connected the horns, otherwise the canbus will trip out the fuse

And that was on the LC GSA ? Thank you

 

[DC]

Have a read of the linked article A nautilus will wake the dead

http://www.docspopuli.org/articles/Motorycle_airhorn_installation.html

Kin ell !! Erm....I don't mid messing with the canbus set up but don't fancy drilling out a new horn and adding pumps etc . Was a good read though and thanks for replying

 

[Micky]

Dunno about this loud horn malarkey, my horn ever only gets used for the MOT

If you need the horn you need the brakes ...

 

[masterman21]

I looked at fitting it to my GSA lc . The Cymark braket that NN sell , say it can be used on the GS and GSA. It CANT be used for the GSA as the fairing is different and doesnt allow enough room !

 

[Nick V]

I would like to purchase the titled Horn and fit to a 2015 GSA. NN sells the horn but they are not sure if it will fit the bike !. The adventure bike shop also sells the horn but say it won't fit the 2014 GSA

Sometimes, it's about pitting whatever ingenuity you have against a seemingly insoluble problem. Almost anything can be solved with enough lateral thought, followed by a bit of prodding and poking.
I would say it's not a question of whether it will fit. It's a question of how you're going to make it fit.

 

[bisbee]

Another option for loud horns is to fit the twin ones from a 2005/6 RT they are reasonably small and don't draw too many amps

 

[kurienp]

Sometimes, it's about pitting whatever ingenuity you have against a seemingly insoluble problem. Almost anything can be solved with enough lateral thought, followed by a bit of prodding and poking.
I would say it's not a question of whether it will fit. It's a question of how you're going to make it fit.

+1

and if you have the creator of CYMARC (Mr Hooton you listening ) lurking around this forum, he will be able to fabricate something for you.