Final Drive Bolt Torque - Ilmberger Hugger

[Rosie]

First posting into this oracle of all things GS so here goes. Just fitting a Wunderlich carbon hugger bought second hand (no instruction came with it you understand). It's the type with three mounting hole in the metal plate that fit to the final drive casing bolts. It's been fairly straightforward but I don't know the bolt tightening torque. Anyone able to help?
P.S do these need threadlock?

 

[terayon]

30Nm no they don't need thread lock

 

[Rosie]

Thanks Dean

Very impressive, thanks. Sorry can't stay, got some bolts to tighten and Carbon to polish

 

[Kenny Rodkiss]

Hugger

Don't forget to turn the small cable holder, that secures the speedo pickup cable,over so it does not touch the three holed mounting plate.

It sits just above and left of the speedo pick up in the rear drive.

 

[Kenny Rodkiss]

hugger

This one here,

 

[Rosie]

Thanks for the tip

I had put an extra plastic sheath around the cable where it touched the plate but your solutions clearly better. Another top tip and pic's too. First time I'm glad there's lot's of crap on the road so I can go out and test the hugger.

I was told it's the longer version carbon one as it comes just about level with the shocks bottom linkage. Hoping that means I don't have to rivet a bit of rubber flap on like some of the ones I've seen recently?

One very impressed GSer Newbie. Now, what else would I like to know?