Ignition lock problem

[stroller]

Switched on the ignition to check my GPS, then switched off while I adjusted the gear selector position. 10 minutes later and the key barrel seems to have jammed - I can't turn it on or turn it to the steering lock position!!
Any ideas how to fix, or is it a case of calling the dealer?
Mike

 

[Commuter]

WD 40

Get plenty of WD40 in there and let it sit for an hour, should get into the stuck bits.

Or if you are in a cold area, hairdryer.

WD40 should do it though

 

[Mouse]

You've probably tried this but wiggle the handlebars while you try and turn the key. If the steering lock is engaged, that is.

 

[chippelmike]

Ignition barrel

My Ign. barrel was jambing regularly before the 6k service @ BVM Stroud. they stripped it out and cleaned all the tumblers (?) it works ok now it was apparently both corroded and dirty so I recon the little flap doesnt work too well.
One the subject of 6k. service the update was installed at the same time MAGIC much better , more go and smoother.
Bad news ( or good maybe ) is that they are going to change my rattly gearbox so maybe it wont sound like a Duckfarty afterwards. Mike.

 

[Emoto]

Do NOT use WD-40 in a lock. Use a graphite lock lubricant. WD will end up making the lock worse in the long run. Mention WD-40 to a locksmith and watch him wince...

 

[stroller]

Called BMW recovery - technician could not free it, so bike on its way to dealer for new ignition barrel. Hopefully parts readily available and not too long to fix.
Mike