Quill Headers

[Cartman]

Anyone running these?

I bought a set at the NEC, got a deal and I have used their stuff before and found it excellent. However they are three piece and have no bracket to attach to the underside of the bike.

I have spoken to Quill who say that they will support from exhaust mount and engine, and that this is not a problem as there is far less weight than having the CAT on. The three pieces are for alignment and ease of repair if you trash them off road, kinda makes sense

just thought someone might be using them and could put my mind to rest, before I put them on the bike.

 

[eden warrior]

got some at the scottish bike show fitted them with akro end can. had the same concerns as you but have had no problems,two services, been to spain hellava lot lighter no worrys.

 

[Cartman]

Ta,thought it would be ok but I like to be sure.

Just finished fitting them, they look good on the bike and the sound is better too. Just got to test ride it now.The bike is smoking a bit though, suppose the electrical gubbins need to sort themselves out.

 

[Cartman]

Now done 500 miles and what an improvement Look fine, bike feels so much better so they were cracking good value after all.