Search:

Type: Posts; User: Santa-2512

Page 1 of 20 1 2 3 4

Search: Search took 0.09 seconds.

  1. As a general question, cost wise what would a...

    As a general question,

    cost wise what would a trip like this be, including shipping
  2. Thread: Service

    by Santa-2512
    Replies
    59
    Views
    1,479

    If a dealer uses the same system & method in...

    If a dealer uses the same system & method in which the fluid is filled at the factory, that is what you would expect to see.

    A modern car spends about 2-5 minutes in each assembly operation...
  3. Replies
    567
    Views
    40,560

    Headlamps marmite, I like it, so all the rest...

    Headlamps marmite,

    I like it, so all the rest can do one ;)

    I suppose the proof of the pudding so to speak will be whats the beam pattern and throw like.

    If it give a good pattern and...
  4. Thread: Service

    by Santa-2512
    Replies
    59
    Views
    1,479

    Yeah, but you only roll it down the drive, once a...

    Yeah, but you only roll it down the drive, once a week ;)
  5. Replies
    8
    Views
    227

    Hid's are an MOT failure, for motorbikes it's...

    Hid's are an MOT failure,

    for motorbikes it's if and only if they are fitted to headlamp unit's they are not approved for

    Hid's are meant to be in self leveling headlight's units fitted with...
  6. Replies
    35
    Views
    625

    I wish ;) Most modern soles are either...

    I wish ;)

    Most modern soles are either synthetic or not conducive to having some pins & segs belted into them.

    And you can forget glueing anything to them, as modern soles have silicone & or...
  7. Replies
    7
    Views
    156

    Battery first off, Starts , runs , stop wont...

    Battery first off,

    Starts , runs , stop wont start, leave for xx time and restarts, as battery has recovered enough.


    for 54 buy a new motobatt or 100 an oddysey

    then it's earths, then...
  8. Replies
    35
    Views
    625

    I have a std size hexhead centre stand availible...

    I have a std size hexhead centre stand availible if reqired
  9. Thread: Knee bend

    by Santa-2512
    Replies
    31
    Views
    1,040

    Have you tried playing the numbers in...

    Have you tried playing the numbers in www.cycle-ergo.com it's verry handy ;)
  10. 2008 would be external temp sensor

    2008 would be external temp sensor
  11. Replies
    35
    Views
    625

    Speak to Denzo, he is the expert on this subject...

    Speak to Denzo, he is the expert on this subject (shocks thata is )
  12. Replies
    10
    Views
    260

    Apology time, i only looked at the hexheads,...

    Apology time,

    i only looked at the hexheads, oops
  13. Replies
    35
    Views
    625

    These are the seat heights for the LC GS 800mm...

    These are the seat heights for the LC GS

    800mm - Extra Low / Low Suspension

    820mm - Low Seat

    850mm - Standard Seat

    870mm - High / Comfort
  14. As with most commercial earbud's / headphones ...

    As with most commercial earbud's / headphones

    they look good, and sound great in the shop, living room, garage etc, but ..

    1st problem, you have to get your lid on, without dislodging the...
  15. Replies
    10
    Views
    260

    Its just a retaining circlip, multiple uses,...

    Its just a retaining circlip,

    multiple uses, accross many factors, not a bike specific item.

    They are normally pretty robust, and need quite a bit of force to remove,

    they dont normally...
  16. Replies
    35
    Views
    625

    To the OP What are these lowering cams you...

    To the OP

    What are these lowering cams you speak of, thats a first for me ;)

    The original Hexhead had a std seat height of 830-850 if i recall

    this could be lowered to about 820mm with a...
  17. Replies
    567
    Views
    40,560

    Never new Dunlop did bearings? SKF to me is a...

    Never new Dunlop did bearings?

    SKF to me is a given, but Dunlop? I thought they were Rubber bods

    It's looking very nice :)
  18. Some of us aren't anywhere near 5'10" lol ;) but...

    Some of us aren't anywhere near 5'10" lol ;) but i'm not going to give the piss takers any more fuel ;) by stepping on a peg to get on the bike, ;)

    I can swing my leg over quite easily and...
  19. Replies
    7
    Views
    129

    The limiting factor in all of this, is the...

    The limiting factor in all of this, is the equipment you have.


    If your laptop , pc wifi dongle set top box, or any wifi equipment, is at a maximum lower speed, thats all your going to get.
    ...
  20. Replies
    5
    Views
    352

    Look at the piccy above there will either be a...

    Look at the piccy above there will either be a locking tab on the outside of the plug, or a tab where the inner wiring is, that just needs to be

    depressed or pulled and then some gentle...
  21. Replies
    101
    Views
    5,650

    The squish band looks very close to the valve...

    The squish band looks very close to the valve seat.

    is that not a risk of getting a hot spot ?
  22. Replies
    78
    Views
    1,040

    Not biker friendly ;) So the car park is on...

    Not biker friendly ;)


    So the car park is on the seafront, and the hotel is 3 streets away,

    what could wrong ;) :cool::rolleyes:
  23. Replies
    22
    Views
    1,547

    No, the android experience is still flawed, i fed...

    No, the android experience is still flawed, i fed that bug back to them when i tried the app on the play store.

    It needs someone to have a look at the app and play with it
  24. Replies
    22
    Views
    1,547

    THe hardware is proppriatry (sp), the software...

    THe hardware is proppriatry (sp), the software open source

    The guys at WL have stated they have taken the software as far as they can,

    so released it as open source, so any developers can...
  25. Replies
    43
    Views
    1,125

    Observation to the OP, unless you can afford...

    Observation to the OP,

    unless you can afford to replace the wheels if your attempts go wrong,for the sake of 50 vs 600 odd is it worth the hassle?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

Anyone attending a Ride Out or Event organised through the UKGSer Forums does so at their own risk.
UKGSer.com or anyone organising an event posted here will not be held responsible in any way for damage or personal injury sustained while attending any such events.

Members attending any such event do so at their own risk.

The text, images, graphics, sound files, animation files, video files, and their arrangement on this Website are all subject to copyright and other intellectual property protection. These objects may not be copied for commercial use or distribution, nor may these objects be modified or reposted to other sites without prior written permission.

Disclaimer: Use or depiction of the BMW logo or trademark throughout this web site is for illustrative and editorial purposes only, and to the benefit of the trademark owner, with no intention of infringement of the trademark.

The UKGSer Forums may include adult content for which it cannot be held responsible. Your use of this website constitutes acceptance of the UKGSER network privacy policy



UKGSer is....

"A vent, a source of info, a source of bullshit, a source of humour and in the coming months, possibly a source of sanity." Big Lad March 2020

"I have always known this community is full good people even if most of you cover it up with piss n vinegar" Chad 2018

"Its about being a grown up hooligan - and if that means a dark visor, remus open pipe and a bit of speeding out of town then all well and good" Kaister 2005