Search:

Type: Posts; User: Santa-2512

Page 1 of 20 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    12
    Views
    272

    The problem with using the pillion grip is your...

    The problem with using the pillion grip is your splayed like a crucifix, and trying to pull on a point far away where you want to apply load.

    If you use the frame bar that runs under the seat,...
  2. Replies
    12
    Views
    272

    Easiest way for me, and i'm a short arse ...

    Easiest way for me,

    and i'm a short arse

    Left hand on the LH grip,

    RH on the frame bar that runs diagonally under the seat. Fingers over the top, not hooked underneath

    Then press down...
  3. Replies
    7
    Views
    227

    Ive just stuck another set of Trailriders on my...

    Ive just stuck another set of Trailriders on my 1200

    I had a set on my hexhead, very confidence inspiring

    https://www.avontyres.com/en-gb/tyres/trailrider
  4. Replies
    25
    Views
    562

    Brilliant, And fair play to you for admitting...

    Brilliant,

    And fair play to you for admitting it :)


    Plum xx
  5. I went from an 06 to a 16 Gaearshift pro...

    I went from an 06 to a 16

    Gaearshift pro fitted as std not aftermarket (mine was )

    It clunks going into first, when cold no, when hot yes

    the clutch is 100 times lighter than on a...
  6. Replies
    13
    Views
    276

    NAv Vi Zumo XT Mobile phone

    NAv Vi
    Zumo XT
    Mobile phone
  7. Thread: XL125S

    by Santa-2512
    Replies
    10
    Views
    441

    I and several other mates cut our teeth on a big...

    I and several other mates cut our teeth on a big old XL250.

    It was owned by my best friend, and was my first proper introduction to motorbikes.

    That bike suffered some horrendous abuse from 3...
  8. Thread: Clutch

    by Santa-2512
    Replies
    5
    Views
    379

    According to real. the plates come as a pack,...

    According to real.

    the plates come as a pack, so i guess that lot wont be cheap
  9. Replies
    41
    Views
    7,674

    I had some replica lights fitted to my hexhead, ...

    I had some replica lights fitted to my hexhead,

    thy didn't have the luxury of the oe power connector, so hard wired and sealed .


    Unfortunately the units filled withe water, not a lot, but...
  10. Thread: Service

    by Santa-2512
    Replies
    80
    Views
    2,759

    No probs When they do the fluid fills, they...

    No probs

    When they do the fluid fills, they do brake,coolant, power steering & screenwash. all on one station, using similar methods

    as you can see in the video, the line never stops, a car...
  11. Thread: Service

    by Santa-2512
    Replies
    80
    Views
    2,759

    Its not theory, it's how it's done - see the...

    Its not theory, it's how it's done - see the video below

    The car is hooked up diagnostically, the pump unit goes in the master cylinder, and the black boxes go to work,

    So first step is to...
  12. As a general question, cost wise what would a...

    As a general question,

    cost wise what would a trip like this be, including shipping
  13. Thread: Service

    by Santa-2512
    Replies
    80
    Views
    2,759

    If a dealer uses the same system & method in...

    If a dealer uses the same system & method in which the fluid is filled at the factory, that is what you would expect to see.

    A modern car spends about 2-5 minutes in each assembly operation...
  14. Replies
    582
    Views
    41,184

    Headlamps marmite, I like it, so all the rest...

    Headlamps marmite,

    I like it, so all the rest can do one ;)

    I suppose the proof of the pudding so to speak will be whats the beam pattern and throw like.

    If it give a good pattern and...
  15. Thread: Service

    by Santa-2512
    Replies
    80
    Views
    2,759

    Yeah, but you only roll it down the drive, once a...

    Yeah, but you only roll it down the drive, once a week ;)
  16. Replies
    13
    Views
    353

    Hid's are an MOT failure, for motorbikes it's...

    Hid's are an MOT failure,

    for motorbikes it's if and only if they are fitted to headlamp unit's they are not approved for

    Hid's are meant to be in self leveling headlight's units fitted with...
  17. Replies
    35
    Views
    644

    I wish ;) Most modern soles are either...

    I wish ;)

    Most modern soles are either synthetic or not conducive to having some pins & segs belted into them.

    And you can forget glueing anything to them, as modern soles have silicone & or...
  18. Replies
    7
    Views
    168

    Battery first off, Starts , runs , stop wont...

    Battery first off,

    Starts , runs , stop wont start, leave for xx time and restarts, as battery has recovered enough.


    for 54 buy a new motobatt or 100 an oddysey

    then it's earths, then...
  19. Replies
    35
    Views
    644

    I have a std size hexhead centre stand availible...

    I have a std size hexhead centre stand availible if reqired
  20. Thread: Knee bend

    by Santa-2512
    Replies
    31
    Views
    1,089

    Have you tried playing the numbers in...

    Have you tried playing the numbers in www.cycle-ergo.com it's verry handy ;)
  21. 2008 would be external temp sensor

    2008 would be external temp sensor
  22. Replies
    35
    Views
    644

    Speak to Denzo, he is the expert on this subject...

    Speak to Denzo, he is the expert on this subject (shocks thata is )
  23. Replies
    10
    Views
    272

    Apology time, i only looked at the hexheads,...

    Apology time,

    i only looked at the hexheads, oops
  24. Replies
    35
    Views
    644

    These are the seat heights for the LC GS 800mm...

    These are the seat heights for the LC GS

    800mm - Extra Low / Low Suspension

    820mm - Low Seat

    850mm - Standard Seat

    870mm - High / Comfort
  25. As with most commercial earbud's / headphones ...

    As with most commercial earbud's / headphones

    they look good, and sound great in the shop, living room, garage etc, but ..

    1st problem, you have to get your lid on, without dislodging the...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

Anyone attending a Ride Out or Event organised through the UKGSer Forums does so at their own risk.
UKGSer.com or anyone organising an event posted here will not be held responsible in any way for damage or personal injury sustained while attending any such events.

Members attending any such event do so at their own risk.

The text, images, graphics, sound files, animation files, video files, and their arrangement on this Website are all subject to copyright and other intellectual property protection. These objects may not be copied for commercial use or distribution, nor may these objects be modified or reposted to other sites without prior written permission.

Disclaimer: Use or depiction of the BMW logo or trademark throughout this web site is for illustrative and editorial purposes only, and to the benefit of the trademark owner, with no intention of infringement of the trademark.

The UKGSer Forums may include adult content for which it cannot be held responsible. Your use of this website constitutes acceptance of the UKGSER network privacy policy



UKGSer is....

"A vent, a source of info, a source of bullshit, a source of humour and in the coming months, possibly a source of sanity." Big Lad March 2020

"I have always known this community is full good people even if most of you cover it up with piss n vinegar" Chad 2018

"Its about being a grown up hooligan - and if that means a dark visor, remus open pipe and a bit of speeding out of town then all well and good" Kaister 2005