Take a row of bricks out
I have dropped a bollock and bought a gsa but just found out the bars are too wide to get down the side of the house. Any ideas on how to make it a few inches narrower ?..
How about some form of front wheel dolly that has castors and allows the front wheel to be turned ?
I'm about to show my lack of engineering qualifications!
Why couldn't you cut out a section in the middle between the clamps and put in or over a sleeve for the required strength?
Just a heads up, I bought one of these so that I could push my GS tight up against the garage wall. The dolly in the picture is too small for the GS centre stand. I had to get the grinder out to make it fit. I then found out that trying to push the bike in a straight line whilst keeping the front wheel off the floor was a difficult manoeuvre, as you have to really push down on the back of the bike to lift the front wheel. If the front wheel drops and touches the ground the bike turns. And finally, the slightest uneven surface or piece of gravel will jam the wheels.I was going to suggest something similar. If the path down the side of your house is nice and flat, or can be made so, then you could put the bike on the centre stand one of these with the bars turned sideways and then push it:
https://www.amazon.co.uk/dp/B01N7MH3I4/?coliid=I37IBXOFR7HJXV&colid=2U8OPBSUJI9MT&psc=1