Found in a toolkit - does anyone know what it fits?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Something like that usually slips over the end of, perhaps, a flat C spanner to extend it for more purchase.
+1
like for adjusting the front suspension preload on a GS1200
That’s what I thought but there’s not a corresponding tool in the kit.
Bloody mystifying!
Wish I wasn’t such a dumb ass!
Sent from my iPhone using Tapatalk
The tubed end fits over the wheel bolt angled wrench
I'm sure you could make something "suitable" Mark
Slots into the screwdriver handle. Same profile as the section halfway down the reversible screwdriver bit.
Not sure if you know Mark, but the end of the screwdriver is shaped to fit into the engine-oil filler plug.