Hi, sorry for starting a new thread on this subject but couldn't find what I wanted to know on the previous similar threads.
I have a 2014 1200GS LC. I am trying to fit an Innovv K2 (front and back camera) system to my bike through a Denali Cansmart Gen 1 system. The camera worked when I tested it out of the box. I have wired up both systems and attached the cameras and GPS etc. I wanted to power the K2 through one of the channels of the Denali (I don't currently have anything on the Denali - saving up for lights! and so only thing on the cansmart is the K20.
I have successfully (I think - followed instructions and no error messages) updated the firmware on the Cansmart and the K2. I have put the K2 on Channel 2 (red and yellow) of the Cansmart (I bought a little pigtail from Denali to make this connection) and set that channel to simple circuit providing 12v switched for a non Denali accessory (on the Denali control software on the Macbook).
Problem - K2 is not powering up. When I put on the ignition the lights on the K2 shiny box (control box?) light up (red, green and yellow, I think) for about 1 second and then go off. I don't think that the K2 is being powered up. I have tried to connect the iPhone to the camera and it is not seeing anything.
Have a missed anything obvious? I presume that the cansmart can deliver simple 12v power and the K2 should be happy with that and start to work. Any ideas? Suggestions? the fuse is fine.
Thanks (in frustration)
I have a 2014 1200GS LC. I am trying to fit an Innovv K2 (front and back camera) system to my bike through a Denali Cansmart Gen 1 system. The camera worked when I tested it out of the box. I have wired up both systems and attached the cameras and GPS etc. I wanted to power the K2 through one of the channels of the Denali (I don't currently have anything on the Denali - saving up for lights! and so only thing on the cansmart is the K20.
I have successfully (I think - followed instructions and no error messages) updated the firmware on the Cansmart and the K2. I have put the K2 on Channel 2 (red and yellow) of the Cansmart (I bought a little pigtail from Denali to make this connection) and set that channel to simple circuit providing 12v switched for a non Denali accessory (on the Denali control software on the Macbook).
Problem - K2 is not powering up. When I put on the ignition the lights on the K2 shiny box (control box?) light up (red, green and yellow, I think) for about 1 second and then go off. I don't think that the K2 is being powered up. I have tried to connect the iPhone to the camera and it is not seeing anything.
Have a missed anything obvious? I presume that the cansmart can deliver simple 12v power and the K2 should be happy with that and start to work. Any ideas? Suggestions? the fuse is fine.
Thanks (in frustration)