Hi,
On my 2019 1250GS, I'm replacing the plastic bit which the numberplate screws into. This piece is screwed into underneath the passenger seat and has bolts like the one below. There's no nut or anything.
Do these need to be re-tightened with a torque wrench and if so, to what torque? Or do I just do them as tight as I can (within reason)?
Thanks
Can't get image to show in page so just a link to it - sorry!
https://imgur.com/a/CmacPQy
On my 2019 1250GS, I'm replacing the plastic bit which the numberplate screws into. This piece is screwed into underneath the passenger seat and has bolts like the one below. There's no nut or anything.
Do these need to be re-tightened with a torque wrench and if so, to what torque? Or do I just do them as tight as I can (within reason)?
Thanks
Can't get image to show in page so just a link to it - sorry!
https://imgur.com/a/CmacPQy