I've just replaced the seals on my 1100GS forks. Topped up with 470ml fork oil each side, but they bottom out when I bleed them, this can't be right.
I re-insert the stanchion , slowly lowering until the oil shows in the bleed screw but the stanchion has bottomed out by then.
There are no leaks and it look like a good job, but surely there must be some available movement downwards for the stanchion?
I re-insert the stanchion , slowly lowering until the oil shows in the bleed screw but the stanchion has bottomed out by then.
There are no leaks and it look like a good job, but surely there must be some available movement downwards for the stanchion?