Can anyone help please
I’ve just finished fitting a hex ezcan with new, 2 cable fitting “interphone Make” aux LED lights.
It’s all connected up fine, circuits are good and lights come on when I carry out the diagnostic test. The test is done via the menu on the ezcan software, but when I click off the test function to return to main menu the aux lights go out and I lose Srl capability too.
I’ve tried the 3 second press of both the indicator switch and the thumb wheel separately to no avail.
What have I done wrong or anyone else had this experience? And fixed it?
Jim
I’ve just finished fitting a hex ezcan with new, 2 cable fitting “interphone Make” aux LED lights.
It’s all connected up fine, circuits are good and lights come on when I carry out the diagnostic test. The test is done via the menu on the ezcan software, but when I click off the test function to return to main menu the aux lights go out and I lose Srl capability too.
I’ve tried the 3 second press of both the indicator switch and the thumb wheel separately to no avail.
What have I done wrong or anyone else had this experience? And fixed it?
Jim