2nd step, 1995 R1100GS driveshaft replacement

here is a picture of the broken end of my driveshaft that needs to be removed.

how do I remove that?

Freeman1100GS said:

how do I remove that?

Click to expand...

multiple wraps of a heavy nylon strap and a slide hammer maybe?

if you could get a slide hammer right on it it would come right off, but that is the issue huh?

some sort of a puller, three jaw clamp behind it, bury the main nut in the recess cut on the front of the output shaft and pull it off.


cut a square of plywood, with a groove to the center to slide over and protect the transmission case.
slide it behind the yoke.

use two prybars on either side evenly prying against the yoke, have a buddy tap the center of the output shaft.

Freeman1100GS said:

how do I remove that?

Click to expand...

Have you any access to a slide hammer?

That yoke should just pop off with movement towards the rear

But start sprayying some release oil around those splines

Freeman1100GS said:

how do I remove that?

Click to expand...

Same as would remove an undamaged drive shaft - Insert a pry bar or large screwdriver in the gap at the front of the driveshaft where is mounts on the output shaft and lever it off.