Changing wheels.

King Rat

Well-known member
UKGSer Subscriber
Joined
Nov 18, 2006
Messages
12,172
Reaction score
1,607
Location
Uttoxeter, England
On the Challenge there is no centre stand and I don't have a box type support or jack. Any ideas how I can prop the bike up off the ground to change the wheels from the small, road ones, to the large off road ones please? I have been keeping my eyes open for a milk crate, but not seen one anywhere yet! I don't want the thing falling on top of me!
 
A large rock or tree stump, hope this helps


Sent from my iPhone using Tapatalk Pro
 
Side stand and a wooden prop or two
 
Try an Enduro trail stand


Sent from my iPhone using Tapatalk Pro
 
As standard the bike has two small brackets attached to the underside of the frame designed to fit the lifting pins on a workshop stand . You can buy a stand from Becker Technik designed specially for the XChallenge which fits into these brackets

c8810ec8041d22b6a73b332da85d2e9f.png


https://shop.becker-technik.de/en/lifter-for-bmw/114-bmw-g650x-lifter.html

Sent from my iPhone using Tapatalk
 
As standard the bike has two small brackets attached to the underside of the frame designed to fit the lifting pins on a workshop stand . You can buy a stand from Becker Technik designed specially for the XChallenge which fits into these brackets

c8810ec8041d22b6a73b332da85d2e9f.png


https://shop.becker-technik.de/en/lifter-for-bmw/114-bmw-g650x-lifter.html

Sent from my iPhone using Tapatalk

I must look and see if I still have those. I haven't noticed anything below the swing arm. Thank you for the link. I shall start saving.
 
Some better pictures of stand and where it fits (note smaller pins are fitted in last two pictures - larger pins to suit HP2 come as standard) :







 
I wish I'd had one of these when I replaced the rear shock on my bike! Rather than precariously balancing it on the side stand with a jack under the opposite peg....
 


Back
Top Bottom