Hi,
I noticed that the cable to the oil pressure switch is looking a bit bare on my X Challenge - not bare wire but there's little or no sleeving/tape left where the wire joins the sensor, almost as if it's been pulled (it hasn't to my knowledge).
Anyone any idea if this connection is part of the main wiring loom or a separate loom or cable? I had a look at the parts book and it's hard to tell.
It looks a bit awkward to repair with tape.
Thanks,
Ian.
I noticed that the cable to the oil pressure switch is looking a bit bare on my X Challenge - not bare wire but there's little or no sleeving/tape left where the wire joins the sensor, almost as if it's been pulled (it hasn't to my knowledge).
Anyone any idea if this connection is part of the main wiring loom or a separate loom or cable? I had a look at the parts book and it's hard to tell.
It looks a bit awkward to repair with tape.
Thanks,
Ian.