G/S Harrison pot

FD2 · Apr 17, 2021

Help please from anyone with a Harrison 6 pot mini calliper.

The set up has two inlet/outlets. The standard GS line fit works but the bleed valve supplied plus the stahlbus replacement I bought are both proud of the calliper by several turns - this is obviously on a dry fit. It looks like it should be running through a banjo fitting - but that wouldn't make sense. I appreciate I might be a numpty but what am I missing?

theoneandonly · Apr 17, 2021

several turns ? or 3 or 4 ? swop fittings around ?

phil_h · Apr 17, 2021

pic required

scooter paul · Apr 17, 2021

The critical issue is wether the bleed nipple taper has seated into the corresponding taper in the calliper, thus forming a seal. The fact that threads are still visible is therefore immaterial. In fact it indicates all is good as you haven’t run out of thread.

FD2 · Apr 17, 2021

I don’t know how to post pictures in a reply.

FD2 · Apr 17, 2021

Photos

Now I do!

theoneandonly · Apr 19, 2021

normal , same as mates basic.

FD2 · Apr 19, 2021

Thanks gents.

G/S Harrison pot

FD2

Active member

theoneandonly

looking over the edge

phil_h

Registered user

scooter paul

Well-known member

FD2

Active member

FD2

Active member

Attachments

theoneandonly

looking over the edge

FD2

Active member

Similar threads