crf250l aftermarket indicators - help!

yofi

Well-known member
UKGSer Subscriber
Joined
Jun 4, 2017
Messages
2,016
Reaction score
74
Location
Midlands
Not sure quite where post to post this request for help, but here goes.

I'm doing a tail tidy, led front lamp and led indictor (front and rear) install on my crf.

Tail tidy and front lights working all ok.

I'm using harness adaptors for the indicators, and I've wired these up in way that is logical order, being black to the greens and the reds to the blue/orange, depending on whether its an offside or nearside indicator. This also seems to be how srmoto have wired their's as well (though different tail tidy).

https://www.honda-crf250l.com/crf250l-turn-signals/

I've install an aftermarket flasher relay (Bike IT).

All I get is the indicator status light for left/right, but the indicators themselves are not working.

Any suggestions as to why or what I could investigate would be most welcome.

I'm assuming the a/m relay would compensate for low draw as well as flash rate but confess I haven't a scoobie.

FWIW, if I put the old relay even the status lights don't come on, which is probably to be expected.
 
All sorted, long story but essentially red goes to black and black goes to red, sort of thing :blast
 


Back
Top Bottom