I know there’s a few threads on hall sensor issues on this forum and others but…I’m a bit stuck. After complete loss of power and restarting when cooled down….then cut out once up to temperature again I got a replacement hall sensor (new from a guy in Greece via eBay). Fitted it and new drive belt, started up lovely got up to temperature and cut out again. This is a complete loss of electrics, the bike is dead until it cools down. I’m going to unplug the lambda sensor when I get home and see if that helps as seen this causing an issue in another forum. My bikes got 17000 miles, abs removed with a gsjohn chip fitted. It did it once after a service last year and then ran fine until last week when I was many miles from home. Waited 5 hrs for a tow, plenty of time to read forums. Runs lovely when it’s not cutting out and trying to kill me….any one had similar problems who could explain what their fix was…..? last go before I head to a proper mechanic.