GS-911 Help needed

LochLaddie

Active member
UKGSer Subscriber
Joined
Aug 21, 2021
Messages
109
Reaction score
2
Location
Scotland
So I managed to get my hands on a 2nd hand GS-911 with 4 registered VIN's

Downloaded the software to my laptop and connected to the unit, all good

Looked at the Hexcode website, connector for a R1200GS (I have a '14) it says under seat, so off to the garage I go. Looked under seat no joy, take the triangle panel off and there is the connector.

Attach the unit to the connector, get a green light on the unit and then connect to the laptop. Software recognises new bike and asks for an auto scan to be performed and to turn on the ignition. Which I attempted to do ....

It thinks the ignition is off .....

So I select select the model in question and the says it does not support my model .... ahhhhh ...

Any thoughts? Have I honestly got the wrong GS-911?
 

Attachments

  • Issue-1.jpg
    Issue-1.jpg
    40.1 KB · Views: 142
  • Issue-2.png
    Issue-2.png
    83.1 KB · Views: 148
Just to be clear, does your GS911 have a round or other shape interconnect?
 
I assume yours is the yellow one? USB only?

Sent from my M2007J22G using Tapatalk
 
So I sent Hexcode an email asking if my GS-911 was compatible with my make and model and it's not ........ "our yellow device will not work with the newer bikes."

Now I need to decide to fork out for a new GS 911 or go down the motoscan route ...

Does anyone know which motoscan version allows the cycling of the ABS unit as I want to change the brake fluid, my rear brake is way too soft and this may help.
 


Back
Top Bottom