Morning all. Whilst teaching the other day the clutch lever on the r1100rt decided to snap clean in half at the engine end. After a 60 mile run through town with no clutch I managed to return to base. A new stainless part was ordered, can it be fitted without pulling the whole bike apart?
Its an RT !!!!! Clutch problem
- Thread starter otruk
- Start date
kennyc
Registered user
I believe the answer is yes.......but it will be fiddly, I believe the official method is to drop the back wheel and paralever, and exhaust muffler.
Soldering wire ???
Pekka
Probably used to wrap around the bolt head and guide it into place, but I often talk bollocks.
Similar threads
