Deleted account 210604001
Registered user
- Joined
- Feb 28, 2010
- Messages
- 0
- Reaction score
- 1
Hi all, I've just pulled off the fairings to connect some Oxford heated grips up to my bike and I have a slight issue, and just want to check for ideas.
There is already a biketrac, optimate and Garmin plugged in using simple circular spade type connectors as below, and there is a small screw which is bolt shaped that goes into the terminal with a fairly shallow thread on it.
There simply isnt enough length in the screw/bolt holding the connectors to add another connector. The options I can think of are
Any recommendations ?
RBW
There is already a biketrac, optimate and Garmin plugged in using simple circular spade type connectors as below, and there is a small screw which is bolt shaped that goes into the terminal with a fairly shallow thread on it.
There simply isnt enough length in the screw/bolt holding the connectors to add another connector. The options I can think of are
- get a longer screw/bolt - (only need a mm or two on the length)
- add a plastic block type connector, remove 2 or three of the connectors and put them straight to the block, then connect the block to the battery
Any recommendations ?
RBW