wiring

My first post. Thanks for allowing my to join your ranks. Well, I have managed to buy a cycle that has me stumped. Apparently it has stump a few owners before me. It has the dreaded EWS error. Also since I cannot find any wiring diagrams that would show voltages or what the pinouts go to what it...

Hi there, I want to wire my BMW satnav prep cradle with a permanent live so I can run a Carpuride screen WITHOUT the BMW GS 1250 canbus dropping the voltage on startup. Therefore I need (I think) a white female plug to connect to the Factory Repair Cable (BMW 83-30-0-413-585) plug connected to a...

Bike 1250GSA: I’ve managed to pull the wires out of the connector from the harness to the front right indicator😱. Is it possible reconnect them myself or do I need a special tool or to I get my local BMW garage to do it?

Hello folks, can anyone share links to a site with images for wiring layout for the 2009 r1200 gs adv? I am now rebuilding one after it was stripped in 2020, senility and loss of images due a corrupt storage device have left me with out the knowledge to correctly refit the...

Hi all, My otherwise very reliable 2005 R1200GS (a mere 55k miles) has finally acquired a fault that kills it... I think there is a broken wire in the stack of cables that come down from the ignition switch. Let me explain... When I switch on the ignition key with the handlebars slightly to...

Hi GSers! The Ignition switch wiring on my F650GS (2001) has chafed on the steering head and could do with replacing. I can get the steering lock end off but only trace the cable (4wires) so far. Where is the other end of it (4 way connector block)? What do I need to do to get to it so I can...

Hi, Anyone installed wiring for the motogadgets M unit v2 for the BMW R80RT (1990)? I am in the middle of making a decision if I should dump the existing wiring loom and install all new wiring with the new motogadgets unit. The only thing stopping me is FEAR!. Yes, I am afraid of the wiring...

I've just bought a 2014 1200gs TE yesterday!. I want to fit the Road Angel Bike Trac that I've taken off my old 1200gsa. It needs a connection to the battery - not difficult - and a third connection to a wire that is live when the ignition is on. On the old bike I took it from the auxiliary...

Guys .. looking for divine guidance or confirmation I'm going down the right route before I blow my Nav IV by wiring incorrectly. I've got another mount to use on an Non BMW bike so no sexy simple accessory plug to connect to. I'm hoping that from the 2 connectors that come off it I can ignore...

Hi all, Need to rewire my G/S. Thought about getting a factory main loom and making the sub looms myself.. Looking at my loom there seems to be a lot of unnecessary wiring. That loom to the front light is a weak spot too (repaired it twice already). Thinking if I swapped out all the BM...