1100 surging, something different...

[PIGGLET]

Picked the bike up on Thursday and did 260 miles no bother.
It was fine on the test ride and fine whils't doing battle with comuters on the M25 however........
When I pulled into the garage near home it was spluttering/surging at about 30,
The usual surge thinks I. Pootled around on it this morning before checking, WDing all the multi plugs, removing the cat code plug and resetting the motronic.
Started it up, runs like a bag of poo.
Deffinately RH side, waggle the injector and it picks up the pot.
Closer inspection reveals the injector mounting bracket with the rubber doughnut in is letting the injector move around a bit.
Waggle it some more bike runs rough then picks up.
Is it possible to get the mounting bracket alone or is it part of the injector?

 

[Noel]

The injector is seperate part to the bracket, you can get the bracket, seal, injector and spring clip all as seperate parts, injectors are £120 each but all the little brackets and seals are no more than a few pounds.

 

[PIGGLET]

I was hoping that would be the case but no-one can identify it on a parts list.

 

[Noel]

Is that just the rubber o ring under the bracket? if it's playing up it's more likely to be the o ring on the end of the injector to throttle body seal letting air in, it's been a while since I've looked close at 1100.
Just found a parts picture,

 

[PIGGLET]

Yeah, thought that might be a problem too. Just ordered a set of O rings and and a 2nd hand injector to try/keep as a spare. It seems the big rubber washer is part of the injector assy and not availabe seperately