1150 gs 2003 servo abs removal

[andrew darwent]

could do with a bit of info on wiring side after removal of abs /servo unit .I have connected all hoses blead brakes all working ok .removed electrical side of abs unit and re connected removed blue relay and dash warning bulb , all lights working ok including brake
is their anything else i should do before putting back together
cheers Andy

 

[DrFarkoff]

Did you seal up the electronics unit and mount it so that it does not vibrate too much and it cannot get soaked???

 

[andrew darwent]

no not yet just making sure there is nothing else obvious that iv missed and any good tips for keeping it water tight

 

[mspenz]

no not yet just making sure there is nothing else obvious that iv missed and any good tips for keeping it water tight

Sounds like you've done it the correct way

You can buy a 10mm thick plastic chopping board for next to nothing and it's easy to cut/drill, screw the module to a suitable sized portion and seal it with some silicon then secure it into that void you now have...job done.