1200 swing arm pivot problems

Steptoe

Him/Bloke/Fella.
UKGSer Subscriber
Joined
Oct 12, 2003
Messages
73,608
Reaction score
22,106
Location
S/W London.
If your 1200 has been used over the winter, or in water, chances are your swingarm pivot is seized - you'd better have it checked before the warranty runs out - loads of them seized after only a few months, and it's not something that you may notice till you have to remove the swingarm.

And then you'll have a nice big bill .

Nice one BMW .
 
:confused:

If the swing arm pivot is seized, would'nt that stop the swing arm from, er ,pivoting???

Haven't heard many complaints about 12's turning into hardtails, or am I being even thicker than usual??
:confused:
 
it means you can't get the swingarm out -


not that you'd have to do that very often, but when you do need to do it you'll be fecked -

and if it's a couple of years down the line ( when it's seized even more), it'll be your problem, when it shouldn't be, as there is a problem now -

i.e. they've been assembled dry , when they should have been lubed.

( You haven't read this here, this could drop someone right in the doo-dah ) :D :D
 
Mouse said:
I would hold him upside down by the ankles, but the real question is how do you check the swingarm pivot?
...:D :D :D better than the 'index finger' check:D
 
I was going to do some preventative maintainence on the swing arm pin/pivot bearings, but there isn't any reference to it in the CD repair manual!
 
If your 1200 has been used over the winter, or in water, chances are your swingarm pivot is seized - you'd better have it checked before the warranty runs out - loads of them seized after only a few months, and it's not something that you may notice till you have to remove the swingarm.

And then you'll have a nice big bill .

Nice one BMW .
21 years later and I’ve found mine welded together!
 


Back
Top Bottom