1200GSA Pannier Lock - Single Key

[ballistic]

I've just got a new set of BMW Adventure panniers, which have the locks fitted, but the 2 keys supplied are different to my ignition key.
Is it possible for me to "re-key" the locks to my existing ignition key, or do I have to go back to the dealer to have it done?
If I can do it myself... a short explanation would be helpful

Cheers,

 

[Funners]

yes you can...I didn't do mine but all three of mine are keyed the same so only the bikes key is needed...BMW did mine for me...
I seem to recall a thread where someone was asking for the different levers from the locks to make the lock up IYSWIM ???

HTH

 

[FlatRabbit]

Its around £20 to get it done by a dealer. The link below is a pictorial guide for re-keying vario lock barrels. The principle is the same, but you might find that you don't have enough of the right tumblers to match your ignition key.

I didn't bother re-coding mine to save wear on the ignition key - I don't want to give my new ring antenna any excuse to play silly buggers....

http://www.advrider.com/forums/showthread.php?t=300753

 

[ballistic]

Its around £20 to get it done by a dealer. The link below is a pictorial guide for re-keying vario lock barrels. The principle is the same, but you might find that you don't have enough of the right tumblers to match your ignition key.

I didn't bother re-coding mine to save wear on the ignition key - I don't want to give my new ring antenna any excuse to play silly buggers....

http://www.advrider.com/forums/showthread.php?t=300753

Good link FR, thanks... might summon up the courage to do it... perhaps have to have a bottle or two first though