2007 GSA Auxillary Light Switch LED has dim glow when bike power off

[SeanFromTX]

Howdy from Texas. First post here. Joined the site as it looked pretty informative. Thought I'd get started with this little problem I've had since around 20,000 miles.

I noticed the LED on the driving light switch had a very faint glow. There's no key in the ignition and the stock factory driving light switch is in the OFF position. If I change the driving light switch to the ON position, the LED will go out. The auxillary lights work fine when the bike is running and the LED on the switch works properly too. I attached a pic showing the faint glow of the LED.

My GSA has 47,000 miles on it now. This issue disappeared for some time, but I noticed it's back again. I've never experienced any problem associated with it so I haven't worried that much. Has anyone else here experienced this problem?

 

[littleredrooster]

Does it go out after 15 minutes? The canbus shuts various things down at various times, 15 mins being (I think) the longest....

 

[SeanFromTX]

Does it go out after 15 minutes?

It does not go out after 15 minutes. It stays on continually after the bike is switched off. I also tested turning the igition to the ON position and it stayed on. However, the LED immediately turned off when the bike was started. Ignition switched OFF and the glow reappeared. I'm no electrical pretend-gineer, but Im starting to wonder if this is a grounding problem.